Licensed & Insured · CGC1533024 · CCC1334177
- Financing Available
- 24 Hours Open
Licensed & Insured · CGC1533024 · CCC1334177
Southwest Florida Soffit and Fascia
The eave is the part of the roof nobody looks at until it fails, and it is where wind and water get in first. We replace rotted fascia, refit blown or missing soffit panels, restore attic ventilation, and close the gaps that let pests into the roof space.
Factory-certified for every roofing material we work on
Why the eave matters
In high wind the pressure under a roof overhang pushes upward. When soffit panels give way, wind and driven rain go straight into the attic, and the same pressure then works on the roof deck from underneath, which is a load the deck was never meant to take from that side.
That pattern was everywhere after Hurricane Ian. Plenty of homes across Lee County came through with the roof covering largely intact and a soaked attic anyway, because the water came in at the eave rather than through the shingles.
The slower failure is water. Soffit vents supply the intake air your attic needs, and blocked or missing venting traps heat and moisture against the underside of the deck, which shortens the life of everything above it.
Aluminum holds its shape in our heat and takes wind pressure better, which is why we lean toward it. Vinyl costs less and will not corrode, which matters on salt-exposed properties near Sanibel, Fort Myers Beach, and Marco Island. We walk through both before you choose.
Four signs your eave needs work
What we repair and replace
Most of this work runs alongside a roof or gutter job, and all of it can be scheduled on its own.
Soft or failed boards cut out and replaced with sound material, then wrapped or finished so water cannot get back into the same spot.
Missing, cracked, or storm-blown panels replaced and refastened properly at the correct spacing so the next storm does not take them again.
Continuous or panel venting fitted where intake air is short, which lowers attic temperature and moisture against the underside of the deck.
Open eaves are one of the most common ways animals get into a Florida attic. We close the gaps and finish the detail so they stay closed.
Wind-damaged overhangs repaired and documented, with photographs for your claim. See storm damage.
Where the fascia has to come off, we take the gutter down and rehang it properly rather than working around it. See gutter repair.
Sound boards wrapped in finished aluminum so they stop absorbing water, which is often cheaper than full replacement.
Where the run is gone, fascia, soffit, and drip edge replaced together so the assembly works as one rather than in patches.
How the work runs
We start by working out why the board failed, because fascia almost never rots on its own. It is usually a full gutter going over the back, a lifted drip edge, or an open joint at the corner, and replacing the wood without fixing that buys you two seasons.
The gutter comes down where it needs to, the failed material comes out, and we check the rafter tails behind it. If the ends are wet, you find out then rather than after the new board is on and the paint is dry.
New material goes on, venting is restored where it was short, the gutter is rehung and tested under flow, and we photograph the finished run. If the work belongs on a storm claim, that documentation goes into the file with everything else.
Who does the work
"People think the soffit is trim. It is not. It is what keeps the wind from getting under the roof, and after Ian we saw exactly what happens when it goes."
Owner | Florida Roofing and Gutters | Licensed CGC1533024 | CCC1334177
Based in Fort Myers. In Southwest Florida for nearly 20 years. Factory-certified for every material we work on.
Soffit and fascia by city
Salt exposure and storm history change what fails first at the eave. Pick your city for a page built around the homes in that area.
Free 12-point inspection
Open soffit is an invitation for wind and water. A free inspection tells you what is sound and what is not.
Almost always water going over the back of a full gutter, or a lifted drip edge letting run-off behind the board. Fix the cause with the board or the new one goes the same way.
Usually yes. Soffit and fascia work is done from the eave, and only needs roofing involvement where the drip edge or the first course of material is part of the failure.
If the attic runs hot and humid, yes. Intake air at the eave and exhaust at the ridge is what moves heat and moisture out. Blocked intake shortens the life of the roof above it.
Wind damage to soffit and fascia is commonly part of a storm claim, especially alongside roof damage. We photograph and document it so the adjuster sees the full extent.
Yes. Two-story and multi-level eaves are routine work for us, with proper access equipment rather than a ladder leaned against a gutter that is already loose.
Ready to get started?
Tell us what you are seeing at the eave and we will schedule a look, or call now at 239-966-7663.
